8/17/2023 0 Comments Chopper gun fiberglass![]() So I would assume if a random pattern to be on the inside of the hull that no cloth was used and no hand lay up was used either.? Unless it was a live aboard with finished surfaces but the hull would be covered anyway and couldn't be seen. There would be no point structurally, or economicaly. What you can see - is NO indication what the boat was built from - only the last layer installed. Techno, - if you see cloth, that was the last layer put in the boat, If you see mat, that was the last layer in the boat, if you see woven, that was the last layer put in the boat, If you see Biax, that was the last layer put in the boat, if you see carbon fiber, that was the last layer in the boat. "If you see mat inside then there isn't any cloth." In many cases, we finish certain areas of TRIADs and STV hulls with a mat top coat - especially areas that will be painted or gel coated as a final finish due to the fact it makes a nice finish. Many boat manufacturers will finish a hull inside with mat to make a smoother and more even and easier to clean surface finish. ".but I doubt any one finishes the inside of the hull with mat." This is a guess." ( yes, and an incorrect one) But woven roving is not used to replace 3 layers of cloth. I wont bother to go into the discussion here on fabric loading, mass, strength, fiber orientation, resin matrix, etc. There is a GIGANTIC misconception that fiberglass gains its "strenth" from mass thickness. Nor how or why these fabrics are manufactured. How would it be weaker that the material it is constructed of ? You obviously do not understand how fabrics "load" under use. Where do you get this from? Are you talking about GUN Roving or Woven Roving? Woven roving is a very strong fabric material. ![]() Its sole purpose is to make in one lamination what would take 3-4 seperate layers of cloth. ".Roving is weaker not stronger than regular glass, slightly. I dont your source for this information but is incorrect. So in this method of use, is chop OK?:confused: There are boat manufacturers that won't use any chop such as Allison, Stroker etc. Do they use chop? I don't know but even in the days of the "hand laid" Skeeter I have seen areas that may have been chopped so maybe they were hand rolling like pro-crap. Skeeter claimed hand laid hulls years ago but ended that claim when Yamaha purchased the company. There are some manufacturers that just won't say. Cajun, no longer in business, always admitted to using chop in their hulls. Again, not all chop, but some layers separating more substantial glass. Champion and Charger have both printed in past brochures their layup schedule and both included chop. Not all chop, just some for mat layers, fill, etc. Any honest Ranger dealer will tell you that ranger uses chop (2 have admitted this to me). I called Pro-Craft a few years back about their claim to being hand laid and they told me that they hand roll out their chopped layers and therefore can call the boat hand laid. These are a few but I'm sure there are more that won't admit it. Moving need to sell.Ranger, Stratos, Champion, Charger, Big-O, Javelin, Pro-Craft, Nitro. Glasscraft Fiberglass Chopper Gun - $500Ĭomplete outfit.They sell new for 4K I am willing to let this one go for 2k. I have an extra set of lines for it, some rolls of fiberglass and the manuals and a book with all information. ![]() ![]() I have a tool box full of parts and pieces that were purchased when the gun was bought. Its was used very little and in real good condition. I have a venus fiberglass chopping gun for sale.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |